This matches a 7 inch clip over mirror mount monitor with with our modern CMOS number plate frame reversing camera. The monitor uses a 60m digital wireless receiver which matched the 60m transmitter for the camera. The CAM103 supplied with this kit is ideal for mounting in the number plate area. It is a very wide angled camera so apart from covering the rear of the vehicle for reversing it will see back down the road. Being wide angled vehicles following will look to be much further away than they really are. The camera is extremely reliable and has good resistance to corrosion. The big disadvantage of cameras mounted low down is they do not see the corners of the vehicle.
The monitor is normally hard wired in and comes with a 3m lead that extends to the power and connector for he receiver. The camera has a short lead to the transmitter, but there is the option to add an extension lead if required. This might be useful if you are using it on a trailer with a lot of thick steel as moving the transmitter will improve reception.
TV System: PAL
Effective Pixels: 960 (H) x 576 (V)
Resolution: 600TV Lines
Sensing Area: 4.880mm x 3.670mm
Scanning System: 2:1Interlace
Sync. System: Internal
Minimum Illumination: 0 lux(LED ON)
Horizontal Sync. Frequency: 15.625KHz
Vertical Sync. Frequency: 50Hz
Video Output: 1.0vp-p, 75Ohm
Gamma Consumption: 0.45
AGC: Auto
S/N Ratio: Better than 43.3dB
White Balance: Auto
Electronic Shutter: 1/50(PAL) ~ 1/10,000 Seconds
BLC: Auto
Power Supply: DC12V
Operating Temperature: -20°C~70°C , RH95% MAX
Storage Temperature: -40°C~80°C, RH95% MAX
Lens Angle: 150° Approx (real world may be different as monitors crop the image)
